Wheelchair powerchair replacement joystick handle disability mobility scooter

Description

Welcome to our shop.  This is a 3D printed joystick handle for electric wheelchairs.  We call this shape the T Post handle.  The handle is approximately 4" (100mm) wide, 1.6" (40mm) tall, and 3" (75mm) front to back.  Included in the purchase is one T Post handle and one allen wrench for the set screws.  It is intended to replace a missing knob, or perhaps is better suited for the user.  This handle was created to fill a need.  Some people lack the dexterity to control their chair in its stock setup and may find this shape allows better contol.   We currently have 5 colors available as listed.  Most chairs come with either a 3/16" or 1/4" diameter joystick shaft.  You'll need to verify which one you have before ordering.  The knob you receive will include a small allen wrench.  Use the wrench to "lightly" tighten the two set screws (across from each other) near the base of the handle (over tightening will strip the threads).  The set screws won't completely prevent the knob from turning, but should prevent accidentally knocking it off.
These handles fit a variety of powerchairs including Quantum, Permobil, Pride, etc
Joystick handle wheelchair powerchair scooter mobility quantum permobil pride controler